how you put a b mech on a new a
- Thread starter jakob-b
- Start date
VillageFox
Steel Member
1) remove new a foldy
2) remove old b foldy and b plate (under the foldy)
3) take the old b plate and put it where the foldy was on the new a and make 4 marks with a marker or something
4) drill 4 holes where u marked it ( what i do is drill one hole then put a bolt on to hold the plate in place then move to the next hole and repete the process, so it is even) or if you have something to hold the plate in place realy tight.
5) put on b foldy and plate in and screw it in tight.(make sure the bottem of the foldy rails are smooth and strait)
2) remove old b foldy and b plate (under the foldy)
3) take the old b plate and put it where the foldy was on the new a and make 4 marks with a marker or something
4) drill 4 holes where u marked it ( what i do is drill one hole then put a bolt on to hold the plate in place then move to the next hole and repete the process, so it is even) or if you have something to hold the plate in place realy tight.
5) put on b foldy and plate in and screw it in tight.(make sure the bottem of the foldy rails are smooth and strait)
VillageFox
Steel Member
i was just about to add that. but just alittle, like 1/4 - 1/2 inch.
brandon kilbury
Super Moderator
mine is bolted pretty far forward,
what i do is tape the plate to the deck where i want the holes, then drill down through the holes so i get it perfect instead of drilling on a marker mark and possible being off a bit. one other thing, the insides of the deck of a new a curve a little, so bolting the plate inside the deck will bend the edges and maybe the bolts too, but its normal i think
what i do is tape the plate to the deck where i want the holes, then drill down through the holes so i get it perfect instead of drilling on a marker mark and possible being off a bit. one other thing, the insides of the deck of a new a curve a little, so bolting the plate inside the deck will bend the edges and maybe the bolts too, but its normal i think