I need instructions on how to build launch ramp!!
- Thread starter Ham.
- Start date
rmaccbik3s
Member
um you nail all the wood together.yea.
swiftsbasher
Member
i thought u just said hey presto and i magicly put itself together
Cody Appelhans
Member
brotherbonez
Member
ummmm dec 2009? wats that like 1 month ago?
shouldnt be talking cause first off
1. your new
2. this kid just wants to build it rite so dont tell him to stfu
3. youve been here 1 month ppl care but you dont
4. just shut up cause you joined a month ago and ive seen you trash talk in like 2 threads already
5. your an idiot so dont post dum shit like this
Riley Hughes
Steel Member
dude you post more dumb threads than this guy ever could. all he wants to know is how to build it correctly. from experience, if you don't build it right it wont last as long.
search google, or bing. i'm sure they'll have something. good luck
scooterkillkidphil
Steel Member
ok so u have been on SR for one month and u have about 150 posts. hmmmm you have a life. And u hate on a kid who joined one month after you. Dont be a dick and dont try to look cool by putting others down.
well i kind of guesstimated the two uhh shoot the side pannells (i lost what they were called) and the just screwed in some 2 by 4s for the ribs. then screw the plywood ontop to you can ride it. terrible discription but really you can figure it out. you learn a lot just by trying it. i used way to thin plywood for the surface and now have holes in mine so i screwed another layer on. just go for it if you really want plans their not that hard to find.
AnthonyPellino
Anthony Pellino
You're the man.
Do you want a trophy?
Seriously, go fuck yourself.
- - - - - - - - - - - - -
For the kid who wants ramp plans...
http://www.diyskate.com/ramps.html
pick your ramp. It really is simple. You build the skeleton of the ramp and screw some plywood on top. All in all, you can make a dialed ramp in 1-2 hours. Don't pay too much attention to the supplies and directions. Just look at the pictures and they should explain themselves.
2 feet for a kicker is reealllyy high. You won't learn anything for a ramp that high, and I'm guessing you are a beginner. Make it 18 inches, its a perfect height. Make it 4 feet wide as well. Just get...
1 shee of 8 foot long, 4 foot wide, 3/4 inch thick plywood (sidewall)
1 sheet of 8 foot long, 4 foot wide, 1/2 inch thick plywood. OR 2 sheets 1/4 inch thick plywood of the same dimensions<-----Best choice.(Surface plywood)
About 10-12 2x4s. Leave some for extra if you fuck up on cutting.(skeleton)
One 4 foot wide very thin sheet metal <----very important for the tranny.
Follow the pictures on the site. Use screws NOT NAILS. Use a jigsaw to cut the wood. Mark your cuts with a sharpie before you cut the wood, or you will be wishing you did.
peachster2
Member
diyskate.com
