stripped SCS bolt. suggestions welcome

Tom Cirbee

Tom Cirbee

Super Moderator
Staff member
i stripped the bolt's head. instead of it being a hexagon its practically a circle. ive been plannig on getting a "stripped-bolt" drill bit, but i also want suggestions that would not need the drill bit.
 
2

2468

Member
u need to get an allen wrench a littel bigger and hamar it in. i did it a couple days ago. be patient it may take 5 minutes to get in deep enough. try it it works
 
Kevin Lo

Kevin Lo

Bronze member
All you do is cut the bolt through the middle of the scs. Then you take plies and you could unscrew it
 
H

Hogan

Member
drill through the back of the bolt like where the threded part stickes out it just turned out when i did that and i had to use that cause the striped bolt drill bit didnt work
 
Dan Holm

Dan Holm

Bronze member
Definitely cut the bolt through the slit in the SCS. I had to do this to two of my bolts, and they came out really easily after they were cut. And when you put new bolts in, use anti-sieze.
 
2

2468

Member
Dan Holm said:
Definitely cut the bolt through the slit in the SCS. I had to do this to two of my bolts, and they came out really easily after they were cut. And when you put new bolts in, use anti-sieze.
Click to expand...

when the bolt is far in you will have to cut the scs also...bad ideah
 
kidadidas2

kidadidas2

Member
wow so retarded how u dont no were da slit is n da scs just cut it off were da slit is n da scs im having da same problem cuting mine of wen my classic slayers come
 
You must log in or register to reply here.
Top