drive wheels

E

.erik

Member
i just ordered some new drive 110 mm wheels off this site. they showed up today and i tried to put my bones swiss bearings into it but they wouldn't fit at all. does anyone have any advice how to fit in the bearings????
 
T

todiecore

Member
Perhaps try lubing up the wheel cup with some speed cream or other bearing lube before pushing them in on a hard, flat surface.
 
K

Kenny O.

Member
what i do, which may not be good for the bearings but w/e, is put the bearing in as far as it will go, then turn the wheel over and put it on the ground so the bearing is touching the ground then i just standon it and it goes in
 
the_SD_local

the_SD_local

I own SR.
Kenny Owens said:
what i do, which may not be good for the bearings but w/e, is put the bearing in as far as it will go, then turn the wheel over and put it on the ground so the bearing is touching the ground then i just standon it and it goes in
Click to expand...
That will work with some WD-40 just make sure you don't put the bearing directly on the ground or you will get dust and dirt in it. Put some paper towels down where you are gonna press it in. Or you can use an axle bolt and some old bearings as spacers and just tighten it down to press them in or any bolt that fits. Make sure you are using some kind of lubrication though.
 
You must log in or register to reply here.
Top