Ethic deck urgent help

[melvin]

Im riding a tilt fork, tilt scs and an ethic deck. But the compression isn't working and my bars/headset keeps shaking. I've used a combination of different spacers (big/small), but nothing seems to work. Any suggestions or tips?

 

[Maximus Prime]

Is the crown race install properly

 

[Billie Rainbow]

which bars and headset and are all the parts original in the headset? 2nd thing to check, is the SCS slit once fully tightened level? as in both 1/2s of the scs tighten equally? that is a common mishap with issues like this.

 

[melvin]

which bars and headset and are all the parts original in the headset? 2nd thing to check, is the SCS slit once fully tightened level? as in both 1/2s of the scs tighten equally? that is a common mishap with issues like this.

Im riding rad bars and have a district headset. Yes all the parts in the headset is original. I'll bring it to my work tomorrow, i think the crown race isn't installed properly.

 

[Grant Schofield]

Com'on melvin you work at sz you have yo make scooters dialled

 

[melvin]

Mate I didn't have the tools at home hence the reason why Iam bringing it to work

 

[Jonah-H]

You need spacers. Ethic deck headtube are mad short, so with tilt SCS+ fork it needs spacers.

 

[devinthedew2]

so if i get a ethic deck and use a tilt fork and a phoenix scs i have to use a spacer that sucks probably not going to get one now.

 

[Conor Greg]

so if i get a ethic deck and use a tilt fork and a phoenix scs i have to use a spacer that sucks probably not going to get one now.

You dont need a huge spacer and it doesnt look that bad.Plus it makes no difference to the headset spin

 

[-Sal-]

how long is the headtube on the ethic?

and also, would i be able to run a vertx smx that is 6 inches with a full proto scs without any spacers?

 

[djs 2233]

I had this problem with my reventon and apex forks, there should be a part in the top part of the headset which is circular with an open part on it, these open parts should only just close or not close at all, i had to cut about 2mm off that so that the ends didn't touch once the compression is tightened. It worked perfect after that, i think it was because the apex fork tube was a bit thinner than usual so this may not help in your case.

 

[devinthedew2]

You dont need a huge spacer and it doesnt look that bad.Plus it makes no difference to the headset spin

Yea I just gotta make sure it doesn't look like crap.