Figured out a ghetto rig compression

[Jon.]

So if you have like a district fork or someother fork that you cant put a starnut in then I thought of this.

You need a ICS bolt, but like an inch or so shorter
HIC shim
ICS cap
topcap
and locknut for ics bolt.


You run the ICS bolt up through the top of the fork then through the topcap which is on top of the hic shim on your fork. Then tighten the ics bolt and put your bars on.

 

[Joe Riley]

A lot of people have done this.

 

[Jon.]

Oh aha I just thought of it.

 

[BrandonWeir]

It sounds better than ICS.

 

[IScoot:)]

want to see this on a scoot,.

 

[Jon.]

The only downside is it requires HIC bars

 

[BrandonWeir]

Yeahh I'd just use HIC before I used this. This would actually be more expensive.

 

[michaelchavez]

yea, people do it with scs too

 

[ConnorD]

lol, im doing exactly this right now. I hate it so damn much its not even funny. to adjust it you have to take the bars AND the wheel off.
for the record ICS was alot better.

 

[Zach!]

i had this with my proride fork and it was better than ics probley cause i used it with scs

 

[TomK]

Not a new idea at all.