Help with district v2-i deck.

[BenKowalski.]

Ok, so I recently got my new deck in the mail and i got every thiing all together but when I try to put my eagle wheel in the back the spacers arent fitting my wheel forcing me to use a razor plastic wheel. I'd like to know if anyone who nows about this deck or has it has had the sam problem or the solution to it.

 

[jab987]

My spoked eagle worked fine. Maybe a defect?

 

[BenKowalski.]

do you have a pic of the back of the scooter?

 

[jab987]

Check the last post on the your scooter thread and its my scooter. You can see the back on the last picture.

 

[BenKowalski.]

ok thanks

edit. No you can't?

 

[jab987]

I meant the bottom near the back sorry. Idk bout your problem though. Try tapping in the bearings more because they most likely are out a tiny bit or slide out the brake then put the wheel in and put the brake back in. Hope this helps.

 

[Hep Greg]

yeah your bearings probably arent in all the way. if anything, just file the spacers a little bit, it wont have any negative effects.

 

[Tomm.]

same, idk what todo?

 

[vincep09]

i had that proble too just tap in ur berings in a lil bit so its flush with the side ofthe core

 

[NickTrella]

I had the same problem all you have to do is press you bearings further into your wheel. Grind down your bearing spacer if nessecary to give more room inside your wheel

 

[Tomm.]

The Bearings are stuck inside my lucky wheels and wont budge.
not sure what to do..

 

[NickTrella]

The Bearings are stuck inside my lucky wheels and wont budge.
not sure what to do..

do you have a bearing spacer in you wheel? take the wheel and tilt it so the spacer is misaligned in the wheel, then take a axel and put it into the first bearing, it i will then hit the spacer, and the spacer is blocking the axel from going all the way through because its misaligned. take a hammer and hit your axel, it will knock the bottom bearing out. then you can easily take the second bearing out. hope this helped

 

[Anthσny]

Okay the same happened to me. I too the whole break out then put the wheel in the spacers then slid it in.

 

[Tomm.]

I got the wheel in, but now i cant get the bolt the whole way through?

 

[Phillip]

Had the same problem with mine, okay, the Spacers are like two lengths so you need to make it so you have the linger end out. Do you understand?

 

[Tomm.]

yeah, thanks helped alot!