This is the shittiest idea i have ever heard how would You remove your grips? And if your grips always throttle you probably suck at putting them on
To remove the grips, first remove the wire. Then break the glue loose using compressed air or soapy water. Next, clean the grips and bars using acetone or some other solvent. Now your grips are ready for reinstallation. It is important to an easily removed glue such as 3M Yellow Super Weatherstrip and Gasket Adhesive. Something like superglue will bond too tightly and require cutting the grips off.
I don't think a lack of grip installation skill is the cause of throttling, at least in my case. I always clean the grips and bars thoroughly with acetone before installation. When I pull them off after throttling ruins my ride, I find water (sweat) inside. In my opinion, the cause is the steady stream of sweat pouring down on the grips when riding in the hot weather. It was 103F and sunny yesterday when I was riding.
Wire + glue has been the standard grip installation method in motocross since the 1970's or maybe earlier. There the use of gloves limits the sweat problem, but water crossings and rain races give enough water to loosen grips. I remember once my brother leading the pro class at a local race only to lose it due to grip throttling. Honda CR (motocross) grips have a special groove that allows a cable tie to be used instead of wire. I used to re-glue my grips before every race.
