Liam Nugent
Member
I have tried twisting them off and pulling them off as hard as i can and i even oiled the slit in them but its still to tight on my fork , and yes the clamp is loosened
I can't get my bars off my fork!
- Thread starter Liam Nugent
- Start date
Connorh333
Steel Member
if you have ICS you probably left the bolt in haha. I do it all the time
nick silverman
Member
what bars and forks do you have and what compression do you have ?
702_dialed_rider
Silver Member
grese the fork before you put the on when you get it off so it wont happen again
Top cap
If your running hic sometimes if its a new top cap the top cap will hand over the shim a little bit. So you can put a block of wood on the bottom of the grips and hit them off. You will see if it was the top cap. if it was sand it down or file it down until its flush with the shim. Then when putting the bars back on put grease in the bars and on the shim and top cap.
If your running hic sometimes if its a new top cap the top cap will hand over the shim a little bit. So you can put a block of wood on the bottom of the grips and hit them off. You will see if it was the top cap. if it was sand it down or file it down until its flush with the shim. Then when putting the bars back on put grease in the bars and on the shim and top cap.
Liam Nugent
Member
i have lucky T standard bars and blunt S.O.B IHC forks , and I've tried for at least an hour and i can't get them off its still to tight
702_dialed_rider
Silver Member
thats why you might of got them stuck because some bars hate ihc forks you might need to saw off and invest in a scs and standard threadless forks