need scs help now!

[Jacobo]

how much do you tighten the scs bolt(the one that goes into your starnut)
as tight as it goes?
somewhere inbetween?

thx a lot

 

[Can]

If you want it dialed, tighten it all the way. Sometimes you can still get it dialed tightening it a little less than all the way. If you have it half way it will wobble and be undialed.

 

[Jacobo]

i tightened it all the way, but then i didnt spin at all when i put the bars on....
it a brand new blunt headset that i just opened from the case so idk whats wrong

 

[ConnorD]

You may need spacers.

 

[Can]

i tightened it all the way, but then i didnt spin at all when i put the bars on....
it a brand new blunt headset that i just opened from the case so idk whats wrong

blunt headsets suck. so loosen it a tad.

 

[Jacobo]

ya i loosened it and i realized i didnt have the compressioncap on
and i put a shitton of bike grease on it and its workin perfect

 

[Grant Schofield]

if i doesnt spin when you tighten the compression then that means you have no crown race/itsnot on all the way. do not tighten the compression all the way youll snap the compression bolt tighten it until it get kinda hard to turn

 

[Micah.]

i tightened mine almost as much as possible, and it gradually loosened but was still dialed. I love scs

 

[OwenP.]

i tighten mine all the way so it hardly spins but when you put your bars in it spins nicely and takes longer to get loose.

 

[SickDistrictChris]

tighten it, but not to the point where it will fuck your bars, that can happen xD and just dont over tighten it cuz that'll ruin the bolts my friend

 

[allyscooterkid1998]

you misunderstood him ^^ and until you can feel that it is getting hard to turn, the weight of the bars will make it spin better, and it will gradually loosen up to a nice point