Old A Deck + Pro Model Headtube

[Matt]

how do you make them work? i bolted it and it still moves

 

[Chris Sanchez]

Uhm i think theres these things called.......b.o.l.t.s? They have something called right sizes? Ahhhhh i can't think.

yeah.

 

[Matt]

i put a 3/8 through the headtube and i put 5/16 behind the headtube and through the bottom hole

 

[Chandler Hab]

dude i thought it was too big.

 

[Chris Sanchez]

Is there a plate on the foldy?

 

[Matt]

yea

 

[Lil Steve]

Did you tighten the bolts? Are you sure its not your headset moving?...

 

[Matt]

ya they are very tight and my compression is too when i push the bars forward hard they move and then when i step on it it goes back

 

[Rob.]

Cut the plate off
then the rails compress to the headtube better.

 

[Matt]

it will still move though wont it?

 

[kyle che]

it will still move though wont it?

no because the foldy plates will be able to bend in

 

[Taylor Feist]

i used a 3/8 in the headtube and behind it

 

[Rob Touchek]

u dont have to cut the plate off just unscrew the things with an allen key and then it shouldent move at all

 

[asianpuff16]

try that^ if its not workin then cut it off

 

[Chris Sanchez]

TAkE tHe PlaTe oFf.

 

[Gary Ryckman]

i didn't even needed to take the plate off, i personally just put the bolt below, and behind the headtube, and it would push against the front plate, it doesn't move for me at all.

 

[idk47]

Should work?

I've ridden it before, no problem

 

[konowaluk]

make thos lil bitches tight as hell

 

[Mark Abramsky]

im running it right now i just used 3/6 on top and 5/16 on the otheres make sure the 3/8 is tight idk y but that was the broblem for me and if that dont fork try cutting the plate off

 

[Matt]

I had an old a headtube on it and it worked good but when I switched to a pro headtube it won't work and I can't fit the 3/8 behind it