Razor pro foldy failure

[ogkush]

I was riding a razor pro but recently switched to a micro reinforced sprite due to the fact the top bolt on the fold pops out every so often. Recently though it has been popping out every time i ride. I was wondering if this happens to you guys, and what are your tricks for fixing it?

 

[TomK]

put a spare front axle above the bolt

 

[Jon.]

delete this thread

 

[scootcb]

Well first of is it tight enough?? but if it is do what tom said.

 

[ogkush]

aigh sounds good thanks

 

[AaronA]

delete this thread

wooow why do you got to be liek that?

 

[Rob.]

delete this thread

No need to be an ass.
Spare front axle will stop it from popping out.

 

[redline582]

There is a spring that goes in the headtube that connects from the top bolt to the bottom bolt, make sure thats in there. i had the same problem.

 

[JonnyJonDogg]

i noob on pro models now.

 

[scootermcinnis]

or if u don't have a front axle use the little metal peice already inside the top of the foldy and it wiil keep ur bolt down if u put it over the bolt

 

[Jordan Jasa]

Lol, anyone else find this ironic? Switching to a micro from a pro because of folding mech problems. haha.

 

[Joe Riley]

^^ i was wondering about that. its usually the other way around. i just got a micro bullet today, and i see why.

 

[Humma]

Is it super super tight?

 

[Jon.]

just tighten it alot an use sh*t bearings on the bolts

 

[asianpuff16]

yeah just use bearings laying around

 

[lukescoot]

yeah it happen to me before to i jsut put and old front axel above the bolt

 

[ogkush]

thanks guys, ill be sure to try these ideas.

 

[Humma]

i just bolted a New A, i just bolted it super tight and it doesnt pop out (im just using the scooter to test it out haha)

 

[Scott Trainer]

u hav to make sure u use bearing or washers and tighten it really good