Julian Scoots
Member
My threaded headset wobbles with my threaded forks. my locknut is on tight and the headset is almost to the point of tightness that the bars wont turn and it still wobbles a little. any help would be greatly appreciated.
Threaded Headset Wobble
- Thread starter Julian Scoots
- Start date
MartinRowlands
Bronze member
Have you checked if the bearing hasn't popped? I had this problem once and the bearing had popped.
Julian Scoots
Member
i literally just put it in today. im almost positive that the bearings are fine.
MartinRowlands
Bronze member
Oh ok no idea then sorry
yoyoflavored
Steel Member
did you install a crown race (er whatever they're called) on your forks?
dpnelson31
Steel Member
Pack it with more grease or look into a sealed threaded headset.
iliveinahouse1
Bronze member
because you a riding threaded
Either you are missing a crown race or something of the equivalent on your fork tube or your headset top cap is threaded wrong or a little to big (manufacturing error, seen it more than once before). Or it could be the extremely obvious, it's not tightened enough. Do you have a locknut on top of the top cap? It's not necessary but it helps tighten it up and helps prevent it loosening also.
You could try packing it with grease or oil and then tighten it further than you can now, it may still be able to spin because of the lubricant.
You could try packing it with grease or oil and then tighten it further than you can now, it may still be able to spin because of the lubricant.
yoyoflavored
Steel Member
WAIT are u riding a mgp with a threaded headset?
Doesn't matter, unless the forks are different to MGP ones then it will still work. The threads on MGP forks extend longer down the tube so that the locknut still works and compresses the headset.