Threaded or Threadless?

R

Randall Dalal

Member
I know this has probably been asked before, but here's my problem.

All my friend's say going threadless is the best thing they did and that it's really easy. But it sounds like a lot of work. What with installing the starnut and all that. I really don't know what to do. So tell me, what are the pros and cons of each?
 
Hep Greg

Hep Greg

Administrator
if you really think installing a starnut is alot of extra work, you're a fucking idiot.

it takes like a minute tops.
 
mdemoss

mdemoss

Member
no im talking about inverted
to tighten or loosen ur headset u have to take off ur wheel and loosen ur clamp
(with a frid fork ) spacers can be a pain in the assss
 
Hep Greg

Hep Greg

Administrator
french ID forks are the easiest out of any fork to run ICS with. you dont even have to take the axle out, you just slide the whole front wheel/axle set up out of the dropouts.
 
mdemoss

mdemoss

Member
not mine when i put muh bars (chromo buffs) on i hammerd the shit out off the bottom of my fork so it duzint come out like that amymore
 
C

chester

Member
SCS and HIC is technically possible without using a starnut. You put a long bolt(the one from ICS) like you were using ics, then put scs over your fork, the bolt would stick out from the scs cap, then you take a nut, and thread it on the bolt. Same with HIC. You got it? Someone tried this?
 
You must log in or register to reply here.
Top