Will this work?

[Bushy]

I don't know that much about compression, i've got a threadless fork, headset, and bars but i don't have a compression clamp or anything.
If I buy this, is that all I need for my compression to work, if I use a stock MGP triple clamp?

 

[Bushy]

didn't post the link :| http://www.skaterhq.com.au/browse/details.asp?ProdID=139325

 

[nitroRCs]

There made for the district fork. Look around (i think Inward Scooters has them) for an ICS kit. That will be all you need.

 

[matr!]

You could get a shim made and sit it inside your clamp with a compression cap, but then you would only have a single clamp on your bars = fail

If you have a MGP you will also need headset spacers to use SCS, a longer shim to use HIC, ICS is the only one that will work without modification basicly (except for putting a starnut in your bars)

 

[jordyskoots]

yes it depends what forks you have. probly the inward ics

 

[Bushy]

i've got a district fork, so uhmmm.. what do i need? sorry im so clueless when it comes to compression

 

[jordyskoots]

get the exact one you were looking at on SHQ

 

[Bushy]

what do i do after that?

 

[Jacek]

ok bushy let me help u out. u have a thrdless fork, headset right? Tell us what fork, and from that we can decide what compression you can use. You can use ICS which is really cheap and simple and works pretty good if you install in right. You can also use SCS (its similar to ICS) but you would have to cut down your bars 2 inches. OR you may be able to use HIC if your bars are OVERSIZED.

So tell us what fork u have and what bars. Dont mess around with that thing you found on SHQ . its a component to one of the compression systems i just named.

 

[Jeremy Dalgliesh]

ok bushy let me help u out. u have a thrdless fork, headset right? Tell us what fork, and from that we can decide what compression you can use. You can use ICS which is really cheap and simple and works pretty good if you install in right. You can also use SCS (its similar to ICS) but you would have to cut down your bars 2 inches. OR you may be able to use HIC if your bars are OVERSIZED.

So tell us what fork u have and what bars. Dont mess around with that thing you found on SHQ . its a component to one of the compression systems i just named.

He has district forks. So that would work.

 

[nitroRCs]

You could get a shim made and sit it inside your clamp with a compression cap, but then you would only have a single clamp on your bars = fail

How would that even work?

 

[Jeremy Dalgliesh]

u need a quad clamp to do that ^^^

 

[Nick Griffin <3]

no.

 

[Jeremy Dalgliesh]

umm.. u get a quad clamp get a proto shim put it in get a bmx top cap ur done..

 

[Rob.]

You should always run compression with threadless stuff. If you don't understand threadless, simply stick to threaded to make your life easier and not overwork your brain.