Manny_Fo'_Fanny
Member
i was trying to be your best friend.
Dialedness?
- Thread starter scootertoot64
- Start date
Bear Grylls
M3MB3R
R-Dubya
Steel Member
At the point that you can make a razor scooter dialed, the only thing on it that is still razor is the deck. So it's effectively not even a razor at that point.
scootertoot64
Member
u could use RUP bars . hot glue wheels. brake with lego inside. etc
BrandonWeir
Steel Member
Yessss. If you know what you're doing it's really easy. If your lucky, your ultra pro might come dialed. It's happened before.
R-Dubya
Steel Member
Stock rup headset and brake = impossible to come dialed out of the box. No way in hell. Maybe with some tinkering, I can believe that rob of all people would be the one to do it. lol
Sc00t3rin
Member
hahah fagg wow...but ya here my dialed as fuck RUP niggas
http://www.youtube.com/watch?v=L-SgqOfDMbc
R-Dubya
Steel Member
hahahahaha the kid at the end "IT'S JORDAN LAGO DIALED!!!"
but damn that is rediculous. Do it with a fully stock ultra pro, I want to see a dialed threaded setup haha.
JUSTDOWORK
Member
your definetly not getting it dialed with a rup brake but good luck
DJ Lee
Steel Member
oh my god, ive dialled new a models. its not really all that hard to dial a scooter. especially an ultra pro. all you need to do is cut the break a bit and put either shrink tape or electrical tape where the spring goes and where the brake hits the deck. ive done it to my pro and it was fine. and you can dial threaded headsets, its a technique of tightening the 2 locknuts.
scootertoot64
Member
^ exazlty
brody01134
Steel Member
i just dialed my french id deck with rup bars and stock headset and stock break, and eagles. pretty sick and it was hard too
scootertoot64
Member
you can dial a threaded it u try hard enuf
JUSTDOWORK
Member
true i just had problems dialing a mad brake on my rup
scootertoot64
Member
yes, my pro mod is Really close to being dialed. i just need to put a lego under the brake spring
Mark Abramsky
Member
nitro with switchblade = uber dialed