Addict deck

[JacobStalteri]

Sorry if this is already a thread but i just bought a Addict JD Sig deck, everytime i tighten it it stays dialed for a little bit but then it starts to make some shitty ratteling noise and it pisses me off. I put a grade 8 bolt in at and it still does the same thing what should i do?

 

[Robert]

make sure the rear spacers are facing the right way then if thats not it check the brake or compression

 

[JacobStalteri]

I made sure the spacers are the right way and i tightened the brake. Its coming from the back not the front.

 

[JacobStalteri]

Bump anything else?

 

[Robert]

check and make sure nothing is loose and if its just that it keeps coming loose get some blue locktite

it may be your bearings or bearing spacers... is it making a low pitched sound or a high rattling sound?

 

[Brandon T]

mine does the same...

 

[Vito]

this may help

Hi guys
The rear axle problem can be resolved very easily.
I have sold many Addict decks and all have been good thus far.
When i first assembled our first Addict, i noticed when the axle and spacers were fitted,the wheel had 2mm side to side movement.
If you tighten the shit out of the axle,you can flex the deck and close the gap up.
This is totally not the thing to do ,as flex will lead to cracking in this area.
Every Addict i have sold i supply fitted 2 speed washers 1mm thick to each side of the spacers.
This gives the wheel no sideways movement , and no need to flex the deck on axle assembly.
The speed washers cost about 50c each.
PROBLEM FIXED

 

[twifletty]

ñòðîèòåëüñòâ

ãäå òî ÿ ýòî óæå âèäåë

 

[Kevin.]

loctite to get the axle tight and unrattly.