an idea for scs with french id unpinned

[ashz893scootys]

ok this would require an ics and an scs
put the scs on without the compression cap in the middle of the clamp and put the oversized starnut into ur bars
then put the striker compression cap in the bottom of the forks with the bolt going through and tighten it
would this work and stop the fork legs from seperateing?

 

[zolof]

i dont think so.
but then again what do i know?
honestly it would be alot easier and better just to pin it

 

[ashz893scootys]

i know pinning would work but i reckon that this might work cause if the bolts pulling from the bottom and the scs is pushing down then it should stay tight

 

[Jason]

Sooooo you wanna use ICS so you can use SCS?

Wut.

 

[ben-pat-bro]

Bro, just pin it
haha

 

[ashz893scootys]

i dont even have a french id i wanna know if it was gonna work so stop saying pin it pin it i dotn even have one

 

[Erwin]

...

 

[Mark Abramsky]

It would work but your basicly only using ics so there's no point in havin scs

 

[Dom Marconi]

no, you guys arent actually thinking about it.
the ics cap rests on the inside of the forktube, not on the part of the fork legs. it would still pull on it and pull it apart.
however, you cuold make it work by putting a really big washer in the bottom of your fork, but then, you would not be able to fit 110 wheels.

 

[JDBen]

Bro, just pin it
haha

 

[ashz893scootys]

dom was right


I AM NOT FUKING PINNING IT I DONT EVEN HAVE A FRID FORK SO STFU

 

[ConnorWyatt101]

JEREMY BEaU did this it works

 

[ashz893scootys]

thank god somone dosent say just pin it lmo

 

[Erwin]

JEREMY BEaU did this it works

last time i saw him he had sz fork and no scs.... prob just got new stuff. i wanna see pics of this if anyone can find jeremy

 

[ConnorWyatt101]

JEREMY BEaU did this it works

last time i saw him he had sz fork and no scs.... prob just got new stuff. i wanna see pics of this if anyone can find jeremy

dude im his best friend i will tell him to send me pics after school!

 

[dezbert]

Just pin it...

 

[Thomas Kananen]

pin it, save the hassle

 

[scott s]

pin it!

 

[Steezeman]

Using ICS with an SCS is the biggest waste of time, it just turns your SCS into a clamp with four bolts, not a compression system. And no matter what compression you use, the FrenchID fork with separate (if it is a bad one, that is).

 

[Michael Rankin]

it would work, but its straight up pointless