An idea...

[Matt]

I have an idea, and I don't know if it will work or not. Has anyone tried to put hot glue inside the micro foldy holes, instead of wasting the money on the resin filler one? I think it might work, because it works so good for the wheels. Tell me what you think

 

[zprestoe]

It could work if you use alot,
But its definetly not as strong as resin.

 

[Matt]

ya I meant like fill the whole thing with it though, like you would do with resin

 

[Jdbug_rob]

my idea:
someone should cut a block of wood to the right size, and hammer it in there.

 

[TJkn126]

i dont really think hot glue would do anything but weigh it down, even when hot glue has hardened it still breaks easy

 

[Matt]

well for wheels it helps a ton so it should fork for the foldies

 

[blaine142]

i dont really think hot glue would do anything but weigh it down, even when hot glue has hardened it still breaks easy

i dont think it would work either because resin once it gets dry its really hard and it doesnt have any like flexibly , but hot glue when it drys is really soft and its really bendable so i think the headtube would just like push back into it to a point then when it gets to that piont it would stop it cuz al the hot glue would compress but i think it would be easier with resis cuz it gets harder and people have already done it and it works

 

[Matt]

where can you get it, is it like liquid epoxi resin or something else

 

[mat]

resin is used because it is extremely hard and strong.

hot glue is incredibly weak

 

[demo]

... i dont know what your talking about... but i think i have an idea...
weld it or eppoxy/resin.. there the best

 

[Matt]

Like instead of putting the resin inside you put hot glue

 

[team_punishment]

you already made a thread haha

http://scooterresource.com/e107_plugins/forum/forum_viewtopic.php?552018

 

[Matt]

that was asking what kind of resin was in it

 

[Andy Rhode]

hot glues too soft to hold shit like htat