Baby scs and bars help?

A

alec logan

Bronze member
Are you serious? You talk so much shit and you can't even solve this simple thing.

Get a quarter/dime and put it in between the threads on the scs. and thread the bolt in through the opposite hole, and keep threading it against the quarter until the scs stretches enough for you to slide the bars down in, then unthread the scs and let the quarter fall out and it should tighten up.
 
.Zo

.Zo

Member
I literally JUST got my shit from SZ and 2 of the things are wrong so its not my fault
 
Noah Fraley

Noah Fraley

Member
put your bolt thru the opposite side u wuld usualy do when u start to tighten it put a penny in front of ur bolt so its blocking it then keep tightening til it stretches
 
Rob.

Rob.

Admin
Staff member
It's a sign from God saying you shouldnt've bought Nawt bars. Haha just kidding.. Uhh.
Put the bolt in from the other side and .. yeah tighten against something. Not rocket science.

Or find a thick screw driver and just plunge it down the slit, making it widen like that.
Or loosen it completely and just jackhammer the bars into it.
 
A

alec logan

Bronze member
Zo dude it's not that freaking hard lmao.

there's probably tutorials on the forums somewhere?

And don't use a penny, your bolt will thread right through it...
 
.Zo

.Zo

Member
Rob said:
It's a sign from God saying you shouldnt've bought Nawt bars. Haha just kidding.. Uhh.
Put the bolt in from the other side and .. yeah tighten against something. Not rocket science.

Or find a thick screw driver and just plunge it down the slit, making it widen like that.
Or loosen it completely and just jackhammer the bars into it.
Click to expand...

I did that and got my bars in but apparently SZ installed the headset without the bottom cap and this silver thing is on my scorchers but I dont know if that is it
 
You must log in or register to reply here.
Top