Bar Reinforcments

J

jgmurch

Member
can anybody explain to me completly how to make bar reinforcments for my deck??? there isn't really a full description of how to di it and i want to make some soon.
 
C

codyferner

Member
no all you do is get that strip of steel or aluminum or whatever and cut to the size of your deck then drill holes in it where your brake bolt, back axle, and plate bolts are.
 
P

proscooter46

Bronze member
Im going to show you how to make some scooter reinforcements.

Tools you will need:
your aluminum square bar
hacksaw
drill
sharpie
ruler
5/16 by 5in bolt with washer and nut

1 step:
get your aluminum
DSC02261.jpg
2 step:
cut it to the length of your scooter
DSC02262.jpg

3 step:
get one of the cut bars and line it up on the side of your scooter and measure were the bolts
are with your ruler then mark them with your sharpie (this is a rough draft with the scraps I had)
DSC02272.jpg

4 step:
drill the top holes big enough to fit the head of the screw through, then drill the second hole big enough to just fit the thread of the nut through that way the head of the screw holds the reinforcement on.(but don't actually put it on)
DSC02268.jpg

step 5: get the reinforcement you already drilled and taped it to the other piece of your reinforcement and drill the holes.

step 6:
take of all the bolts your reinforcements go's and put it together.
DSC02266.jpg

DSC02271.jpg

DSC02265.jpg
Hoped this helped and feel free to ask me any Q's about making your reinforcements
or if you want me to do more detailed steps on how to make them.
 
J

jgmurch

Member
haha thanks dude, but i was was talking about another kind. but thanks anyway, i might just do those anyway. :)
 
You must log in or register to reply here.
Top