Bar rotation tightness

[Tmazz]

Hey guys,

I have Razor Pro model, got it about 6 monthes ago.

I'm having a problem with it, so I'll explain the best I can
Ever since I got it, when I try to barspin, the bars don't rotate enough, they like get stuck in the middle of the rotation. After a while of warming up, they get a bit looser.

So I'm tired of face-planting on bar spins cause it doesn't rotate 360 degrees. Instead it rotates like 270, then the front wheel lands crooked plunging me foward...haha

So anyone have a solution to this?

 

[Matt Money]

loosen the nut above the headset, but not too much because it'll wobble
if thats not it, grease the headset bearings

 

[scootermcinnis]

yeah you have to find a good balance between being able to spin and how tight the headset is

 

[mat]

clean/oil the headset and loosen the big nuts

 

[scootin24/7]

losen the clamp, then unscrew the bars then take off both of the nuts, then take out the bearings and clean them , if u have grease then grease them if not it will still do fine, then tighten it all back together

 

[Matt]

how do you recommend cleaning them

 

[Tmazz]

got it! woo hoo

I found the "balence", I guess it was just a bit tight. didn't really have to grease anything, luckily.

Thanks a lot guys, you were a great help

 

[Graham Todd]

You may need a new headest. Or just take your bars off and loosen the nuts.

 

[Tmazz]

You may need a new headest. Or just take your bars off and loosen the nuts.

I just loosened the big nut. helped a lot