bar wobble. help!

[Ian P]

i have the same problem its because alot of threaded headsets fit the headtube but not the fork deal with it or save some money to go threadless

 

[-Sal-]

ahh i dig that. i guess ill just try to get my inward extreme to work.

 

[Rob.]

Wait.
Make soda can shims. Like cut up some cans and put them between the clamp and the bars, stuff them in there while the clamp is as loose as possible then tighten the hell out of it.

if that doesnt work idk take pictures of your set up

 

[Kroto]

Are you lock nuts tight? because on my mgp when they are lose my bars wobble like fuckers when the lock nuts are slightly a bit lose so try that?

 

[issac miller]

okay, what kind of inward bars do you have. if you have victory bars then they're oversized and that's your problem.

 

[Kevin Lo]

Take a like business card and put it around the bars and put the clamp over it?
Or maybe it could be your slit, did you try cutting 2 slits?

 

[-Sal-]

i already have a shim, and it works fine because i used it before on my old set up.
i have razor ultra pro bars and a lucky threaded fork.
and idt i would want to cut two slits into my bars, its too complicated and i would problably mess it up.
i think im just going to need to use my old inward fork. but does anyone know the size of the bolt and what spacer i should use for aluminum tilt pegs and an inward zero offset fork?