Bearing Pegs Help

[Victor C.]

hey guys, when my nitro, im gonna make bearing pegs. is this a good idea? do they hold up? im not doing rails, just little boxes and stalls. Mainly tooth and 50/50.

im thinking 1 Bearing spacer, and 5 bearings for the front peg (just over 2 inches long), and 1 Bearing spacer, and 3 bearings for the back peg (just over 1 inch long).

Lemme know if this is good, or if they will snap or anything please, i dont wanna eat shit doing tooth's, it hurts.

ty

 

[BenJelinek]

no. just get normal pegs
bearing pegs are okay for a little while but they really are shitty. plus, your pegs are supposed to be the same length.

 

[Victor C.]

yeah but i had pegs before, and they were each 2 inches, but since the back end of the deck is bigger than the fork, the back peg sticks out more than the front peg. but thanks, i will see if i can get some, if not, il just do this for the meantime.

 

[cody]

You could of just cut the peg? Why did you get rid of them?

 

[Victor C.]

scooter got stolen, pegs were on it. Havent seen it since. I know who stole it, but they ditched it, and i have no proof it was them, and no idea where it is.

 

[Victor C.]

bump if anyone has done this before, does it last? and im putting 4 or 5 bearings on each

 

[dpnelson31]

Dude, 8-10 bearings are like 10-18 dollars. Pegs are like 20. Buy some pegs. If you're really that cheap, get sockets from the hardware store.

 

[Victor C.]

no i already have the extra bearings laying around... haha ive already made my mind up, im gonna use the bearing pegs, until i can buy some online.

this can be locked. thanks

 

[KieranPeterson]

Go on forum
Ask question
Deny answers
?????
Profit

 

[skooterdood32]

I made 2 bearing pegs.. It works good for stalls, but its hard grinding with them unless its on a smooth rail or metal surface