Clamp Related Wheel Problem :/

[Ribs96]

Hey, I just got my MGP pro today and tightened the clamp the tightest it can go, but today when I used it for just a few basic tricks, I realised my wheel was turning to the side a little, going out of place so the handle bars are not straight with the wheel completely.
Is it just me or does anyone else get this problem? :/

 

[Noah.]

cut the slit bigger

 

[Ribs96]

how? :/

 

[swiftsbasher]

with a hack saw or something similar

 

[dpbailey]

is the fork threaded?
if so make sure the bars are threaded all the way down as far as they can go and then tighten the clamp as tight as you can

 

[dpbailey]

bump

 

[Jon.]

ok double penetration bailey, you don't bump someone else's thread after 10 seconds.

 

[Rob.]

Seriously. ^
if you post "bump" one more time you're getting dp'd

 

[risser]

if you post "bump" one more time you're getting dp'd

clever post of the day, by Rob Regad

 

[swiftsbasher]

it is siq worthy

 

[kyle likes to scoot]

Seriously. ^
if you post "bump" one more time you're getting dp'd

sigged..

 

[Zero Gravity NW]

Cut the slits bigger with a grinder that has a metal cutoff wheel in it. That or a sawzall with a metal blade in it. Drill a hole at the top of your slit to prevent cracking. Wear safety gear when cutting the slit.