Custom Bar Extenders

[Dallen.]

Finally got the solution to bar extenders. Require no drilling or screws, just push them in and hammer lightly until they are snug. Fit in all bars I've tried. Bar ends fits in the end still. Don't even notice them while the grips are on!

They add a little more than 3/4 inch to each side of your bars

 

[Manny_Fo'_Fanny]

What is it?

 

[Dallen.]

A piece of metal. It fits on one side inside the bars and the other is machined to match the outside width of bars

 

[jake bradley]

mass producing them? if so how much, I'm willing to buy some.

 

[Keenan Still]

you could mass produce these, hella people would buy them

 

[Dallen.]

I am mass producing them!!! Look in the for sale thread

 

[.Gerrit]

jimvanvelde made some bar extenders exactly like these. You should contact scooterzone or some other company to mass produce these, with you getting a portion of the profit.

 

[issac p]

so you just push them in? that doesnt seem like it would stay tight.
pics of the part that actually goes in the bars?

 

[Dallen.]

I'll take more pics later and showing how tight they go in...hold up

 

[Dallen.]

1st pair done

 

[cralle]

That a pic of how far into the bars they go.

 

[Dallen.]

Here

 

[JCott]

i invented many types of this long long time ago

 

[Dallen.]

i invented many types of this long long time ago

sweet

 

[Kevin Tuohy]

are you able to take them out? if so, id buy some

 

[Dallen.]

Yeah they come out. All bars are different, but on my epic rewinds they fit snug but I can also pull them out if I pull hard enough, like hard haha

 

[Dallen.]

They come out if you bang them on the ground like side to side...

 

[issac p]

so they really arent secure? they look like they'll just fall out

 

[Dallen.]

No they don't fall out. Hammer in. Then hit side to side to loosen them

 

[morgan_bvrns]

Aren't these just copper pipe fittings? Like to go from a smaller to larger pipe size? I could get like 10 of these at Lowe's for a buck. They won't last long at all if you're not using barends, either, cuz they're copper. It'll just dent and bend and get ruined and possibly stuck in your bars.