Cutting down one piece bars

[D= its sam!!]

err alittle risky

only if your a idiot, just make sure you mark everything up with a marker or somthing and make sure everything is cut in the right place and it will be fine.

 

[AJ]

that was pointless. wat if you wanted to ride them again later on in life when you grow. now they are too short. o well have to buy some more, when you coulda kept the taller ones

 

[gil_]

dude im like 5 10 im not gonna grom MUCH more. and if i do it will take a while and ill probably be done before then so yeah

oh and ps- im not even gonna cut em anymore lol

 

[AnthonyPellino]

Ok, this sounds odd, but I used a drill gun to widen Andy Rhode's bars because the slit was way too thin. You could defintly use a drill gun to widen and lengthen the slit. Worked like magic for me.

 

[AJ]

i thought you already cut them. that was someone else who posted that picture. if you didnt cut them just do w/e you want with them. i was just saying if you did

 

[dre]

so your saying the slits go to about 15mm to 20mm above where the fork goes?

well if you have super long forks then you definitely don't want to do that haha. Just cut em to like an inch and a half or something, whatever it is on stock bars.

 

[gil_]

im not even gonna do this anymore so its cool

 

[P4RK3R]

so yeah ive had my one pieces for a while now and i think they are to tall for me. so i wanna cut em down like an inch or so.

so to do this can i just cut it to the heigth that i want and just make new slits?

and if i can do that how wide should the slits be?

and also, is there any other info i would need to know before doing this cause i dont wanna go and fuck up me bars

ill do it for you for free