fuzion scooter bottom headset cup

[zakmak]

i just tried to make my neihbors whippable but theres like somthing literally through the cup holding it in and i can't get the damn thiing out.
it is a blank head on the screw(no place for a allen wrench screwdriver or anything) and on the inside it just like pushes outward and it's super strong.

does anyone elses fuzion have this?

 

[the_SD_local]

Don't know exactly what you are talking about off the top of my head but it sounds like a rivet... just drill it out.

 

[razorrider02]

drill it out like andrew said or you can cut a line in the head of it with a hacksaw and then use a flathead screwdriver.

 

[dre]

I don't think you need to take out the bottom cup to make a fuzion whippable. You either can use some spacers so lower the front trucks, or the easier way is to get some skateboard wheels and put them on the front truck because they're small enough so that they go under the deck..

 

[zakmak]

thats what it is! i couldn't remember the name but yeah it's a rivet and you half to replace the cup because the cup is bent on both sides to make sure it doesn't spin. the race also has things on the side that hit the bent cup which prevent is from spinning.

thank you guys.

 

[Derek Scootz]

can you still carve with a whippable fuzion?

 

[zakmak]

oh yeah. it might hit on the sides though when i get one i will tell you. some people on here can i have seen 2 people whip one and it was theres.

just wait someone will say

 

[WayFastRevo]

yea u can still carve but if the wheel touches the frame you suddenly stop and go flying foward

 

[Steezeman]

Get a hammer and bash away bro.

 

[zakmak]

when i get mine i will do whatever i just couldn't ruin her;s since her parents think i don't know shit about scooters after riding for a year.

 

[Steezeman]

Oh yeah, you can totally carve and if the wheels hit the deck they just slow you down, they don't lock up or anything.