Grit Invader with integrated HS

[ScooterEnthusiast33]

I recently bought a Grit Invader with an integrated Neco Headset. I have tightened it up to just the right point that I like. After getting the bars on and tightening the clamp up as much as possible (Included lightly stepping on allen wrench) There was still movement. I could feel the bars wiggling back and forth a little and a clicking noise when I put any weight on the bars. I am really keen on these things because of the fact that it could hurt a rider or the scooter. Please, if anyone knows how I can eliminate this movement (Or if my scooter just needs to be broken in some) Tell me ASAP. Thank you!

 

[Aussiebro]

What compression does it have?

 

[ScooterEnthusiast33]

I think the headset is a Neco integrated headset and it uses and HIC compression system not SCS, if that's what you meant.

 

[Hamish C]

Tighten the headset til it feels a bit too tight because once you put the bars on it will feel a bit looser than it would with the bars off.

 

[ScooterEnthusiast33]

Th

Tighten the headset til it feels a bit too tight because once you put the bars on it will feel a bit looser than it would with the bars off.

thanks

 

[zach poon]

And never step on the allen key when you tightning your clamp tighten top to bottom little as a time or else it wont clamp even and it will be hard to loosen it... And you can strip your bolts

 

[ScooterEnthusiast33]

And never step on the allen key when you tightning your clamp tighten top to bottom little as a time or else it wont clamp even and it will be hard to loosen it... And you can strip your bolts

Thanks, I didn't mean I stepped on them and tightened them one at a time. I tightened them bottom to top until I couldn't tighten them with my hand and ten I tapped it with my foot. The cap cylinder thing that gets bolted on that uncovers wen you take te bars off, that cap is plastic. I didn't know if that would affect anything though. I might just need to break it in more and ten tighten it. Thanks again though.

 

[zach poon]

Thanks, I didn't mean I stepped on them and tightened them one at a time. I tightened them bottom to top until I couldn't tighten them with my hand and ten I tapped it with my foot. The cap cylinder thing that gets bolted on that uncovers wen you take te bars off, that cap is plastic. I didn't know if that would affect anything though. I might just need to break it in more and ten tighten it. Thanks again though.

Your supposed to tighten TOP TO BOTTOM but yeah dont even step on it a little you should be fine