How Can I Unbend A SR Threaded Fork??

M

metrocardscheme

Member
So i bought this fork from jorje he said he sold it to me fine. I rode it around the block to get used to it.I did a few bunny hops and nuttin big, I think he bent it then he bent it back and sold it to me w.e.

So how can i unbend this fork?

its threaded btw

f.cuk jorje
 
J

jorje

Member
lol, dude would you shut the hell up i didnt send it to you bent. i probably rode it the same amount as you. so seriously shut up.
 
I

idk47

Steel Member
unbentfork.jpg

that should do it.. that's how i unbent my stock threaded. idk if it will work on SR's but im pretty sure.. just use that and figure it out.
 
I

idk47

Steel Member
try hammer. or put the tube in a vice and carefully pull back on the legs and plate and try to see if you can bend it a lil.
 
G

gorrilaman

Member
You could try and hammer it so that it looks straight to your eyes and then put a pipe which fits perfectly into the inside of the fork and start hammering the pipe so that it sort of straightens the fork even more. I don't know for sure if it would work. Perhaps Andrew or Madis have a better idea. Also , you should post some pictures. It would be easier for people to understand your problem.
 
M

metrocardscheme

Member
its slightly bent towards me were the clamp goes.i tryed puting a t tubein i hammered it in and pullled back .. i forgot to take pics i woulda.. i jus put my fork back on im a reinforce it tomaroow. i dont want it to get worse
 
You must log in or register to reply here.
Top