How do you bolt this?

I

I like scooter

Member
I don't know how to bolt my bars like this? And I don't know what materials I need, can you guys tell me all the info on what I need and how I do this?
Here's a pic of what I want it to look like but with better bolts.
Austin Komlodi said:
skoot002.jpg
Click to expand...
 
G

ghost24

Member
I used a bolt and one those nylon nuts, with the piece of nylon in it at the end....idk how long the bolt is though lol.
 
C

capron

Member
use 2 front axels and take out the two clips on ur bars then drill through both sides and put a front axel in and tighten do the same to the other side and dont forget to bolt ur t-tube
 
B

Brian Boston

I got myself banned.
Basically what that dude said. Get 2 fork size axles, pop the little gold pieces out of your grips, get a drill bit the same size as the hole in the bars, and drill through the front side of the grips/tube, then put the axles in there. If its not tight enough add a couple of washers.
 
M

mat

Steel Member
any store that sells metal or pipe. a good hard where store or plumbing supply shop should have it.

or support the sport and buy it from the SR store
 
gil_

gil_

Steel Member
if you buy that crossbar he would have to do a ton of sanding for it to fit in the t tube
 
J

jorje

Member
no if you want to make them wider you need 7/8 tube and then you put it in drill through the two holes and put axles or bolts the same size as an axle in there
 
M

matthewcarbotti

Member
nice sam im likin the graffik logo lol yea just take som bolts and a drill oh yea and some washers and drill through the holes and put the bolt and washers in it how wide do u want em?
 
S

skinner

Member
find a bar that fits, cut it down to size, put it in and bolt it through those holes where the buttons are supose to go.
 
You must log in or register to reply here.
Top