how do you make box reinforcements for a pro model deck?

[Jacob Alexander]

i've done it before and failed.
i no there already has been a thread on this, searched, and failed.
pictures or videos would be nice.
i want to have them like the viking reinforcements like with NO cut off edges in the back.
NO FLAMING IS APPRICIATED.

 

[JDBen]

you buy the right square tubing (i call it "cubing") and drill the holes in, and if you want you can cut angles off and stuff too

 

[ConnorWyatt101]

i made some i will sell to you

 

[Jacob Alexander]

no thanks id rather make them. how long r pro models? i dont have one because im ridin a tsi rite now but im buyin a ultra pro soon and i wanna reinforce it.

 

[buffa]

um you have to drill holes in the front on the deck of the ultra pro

 

[Jacob Alexander]

crap, u do

 

[Jacob Alexander]

ok il just buy a pro model also

 

[MattThomMakesMeWarmInside]

just buy the pro model, then cut it to the length of the deck. Dont worry about measurements just sit it next to it and mark it. Then drill properly. In the front on the front side of the tubing, the holes need to be big, but on the inside they need to be small so you can put the front screws in and they have something to hold on to.

 

[Michael Rankin]

just bring all the parts to me and ill do it for you the next time you are at cvs

 

[Jacob Alexander]

k il go get the square tubing this week do i dont gota haksaw u gota driill?

 

[Michael Rankin]

i have a drill, a cut off wheel and a hacksaw. just bring the parts to the skatepark and ill drill and cut it for you

 

[Jacob Alexander]

k so just bring the square bar?

 

[Ryan Kang]

just use your tsi...

 

[Jacob Alexander]

i no but i wanna make a extra scoot

 

[Steezeman]

If you want to get serious, make two marks at the front of each piece of metal, one at 20" and the other at 19.5". Cut between them, so it's an angle, and this will line up with the slant that's already at the front of the deck. Then drill holes where all the holes are on your scooter (two in the front, one for the axle, one for the brake), then slide a back wheel spacer in the back where the axle goes so that it doesn't get crushed when you ride.

 

[Michael Rankin]

no bring the square bar and the deck so i can cut it to the deck

 

[Jacob Alexander]

so i dont have a deck yet im selling my slayers somewtime next week to my friend after that im gonna buy the pro model so can u just do it in like a month or when i get the deck?

 

[Michael Rankin]

i can do it whenever

 

[Jacob Alexander]

k