HOW TO MAKE STRIP REINFORCEMENTS (FOR FRENCH ID DOESNT REALLY MATTER THO)

P

proscooter46

Bronze member
just take ur scooter too a hardware store and find a strip that is the perfect size and then just match up ur holes from ur deck to the strips then just drill it and bolt it.
 
Rob.

Rob.

Admin
Staff member
3/4th inch wide.
measure out the distance between the holes, or paint on your bolts and press the reinforcement perfectly against it, and drill through it.

1/4th for the brake hole, 1/4th for both front reinforcement plate bolts, and 5/16th for the back axle.
 
S

str8rippen108

Member
or maybe i dont feel like taken my scooter into my home depot and look like a asshole with big ass aluminum strips trying to eyeball sizes ?
 
dezbert

dezbert

Steel Member
Common sense.....
1)Get a measuring tape.
2)Measure the dimensions of your deck to see the sizes of the strips you need....
3)Go to home depot.
4)Buy the strips.
5)Measure out where the holes are on the strips.
6)Drill out the holes.
7)Put the strips on your fucking scooter and go ride

;)
 
S

str8rippen108

Member
i dont even have my fuckin deck yet ok?i just ordered a fid and i wanted to kno so i could have the reinforcments b4 it got here and i could ride the first day and not do all that when i get it
 
M

mat

Steel Member
buy chromoly ones from me

but really, get some 1/8" thick 3/4" wide steel strip from the hardware store, cut it into two 20" long strips, carefully mark where the holes go, make sure they are in the right place, drill the holes, cut a bit of the front off at an angle.
 
You must log in or register to reply here.
Top