How to put 4 bearing pegs on the back of pro models
- Thread starter Behlau
- Start date
gorrilaman
Member
You need a long 8mm thick bolt. 130 mm long is good. Put the bolt through everything and put spaces at the end when it comes out. Put your bearings and tighten it.
I suggest this way. Put 4 bearings inside the bolt first. Put the washers inside and put the bolt through all the shit and at the end where theres no pegs, you put your nuts. 2 nuts is better. That way if you land by accident on that place, theres no nut which can unscrew.
I suggest this way. Put 4 bearings inside the bolt first. Put the washers inside and put the bolt through all the shit and at the end where theres no pegs, you put your nuts. 2 nuts is better. That way if you land by accident on that place, theres no nut which can unscrew.
farmboy uk
Steel Member
yea don't put the nuts on the peg side
gorrilaman
Member
Can you find long bolts?If you can, can I trade with you 4 bearings for 2 bolts?So hard to find them here.
stefetrucki
Bronze member
I use a threaded rod. much cÃ?Æ?Ã?â??Ã?¢ââ??¬Ã?¡Ã?Æ?ââ?¬Å¡Ã?â??Ã?´heaper and if you use it right, it's very strong, but I'll get some steal rods abd thread them myself.
gorrilaman
Member
stefetrucki said:
Yeah I thought threaded rods are for like if you need very long bolts but hard to find. How do you use it?Cut it?
gorrilaman
Member
stefetrucki said:
gorrilaman
Member
stefetrucki said:
gorrilaman
Member
What the hell?I quad post?Whats wrong with my com or SR?I click post and nothing happens and click again and again and then I see that I quad or double post.WTF.
I am very sorry admins. Delete my post if you can.
I am very sorry admins. Delete my post if you can.
stefetrucki
Bronze member
it doesn't matter...
Ok, we talked about it on msn, but to answer the question for others,..
I cut the threaded bolt with a hacksaw and then I file it that i can use nuts. and my setup are 4 bearings on each side and to fix the bolt correctly i fix it with nuts right at the fork
Ok, we talked about it on msn, but to answer the question for others,..
I cut the threaded bolt with a hacksaw and then I file it that i can use nuts. and my setup are 4 bearings on each side and to fix the bolt correctly i fix it with nuts right at the fork