lock

[greg m]

when i put my bars over my hic shim it slide up when i jump... i have oversived crows with an oversized scooterzone clamp and the shimm that comes with crows...i tighten my clap to the max!!!
why dose it do this?
how can i fix it?

 

[Devin Catron]

tape over your HIC shim

 

[ConnorD]

^ exactly

 

[greg m]

i tryed that... the tape just got pushed down......
what tape should i use?

 

[Victor Saldarriaga]

make little threads on shim by using sand paper but dont sand it going up and down sand it side 2 side so your crows will not move up

 

[greg m]

make little threads on shim by using sand paper but dont sand it going up and down sand it side 2 side so your crows will not move up

that worked for you or what?

 

[DJ Lee]

grind down the edges of the topcap to make the diameter a bit smaller, thats what i had to do

 

[JoshNunez]

you have SCS greg, use it

 

[DJ Lee]

hic is lighter and less bolts

 

[greg m]

you have SCS greg, use it

scs is to heavy... expecialy since ive been riding flat alot

 

[JoshNunez]

well i guess, if you are a pussy jk

 

[BenJelinek]

I would use HIC too

 

[greg m]

well fuck!
i still kinda need some help lol

 

[Zach!]

just tighten the top cap the most you can and put locktight in your star nut and then put tape in your shim and tighten your clamp to the tighest it goes

 

[greg m]

there is nothing wrong with my compresion jusy the shim its selff... so the tape thing will work? what kinda tape?

 

[Devin Catron]

greg bring it to my house some time this week. i think i can help you

 

[greg m]

yea?

 

[JoshNunez]

try electrical tape, that should work

 

[FIVEO]

I think I had the same problem win my new crows. I found the shim rad supplied was 5/8 an inch taller then my previous hic shim so I marked it and cut it down. Worked perfectly now. Not sure why they made it so long... I couldn't even get the threads started on the top cap.

 

[greg m]

I think I had the same problem win my new crows. I found the shim rad supplied was 5/8 an inch taller then my previous hic shim so I marked it and cut it down. Worked perfectly now. Not sure why they made it so long... I couldn't even get the threads started on the top cap.

oh ok... i dont think mine is hat much higher than my fork.. but i will do that
yea ihad to use an scs bolt cause the other bolt didt reach