Jon.
Steel Member
How to:
1.first off find a screw that fits it the threaded hole in the bottom of the camera, about an inch.
2.find a bar/grip from a razor scooter or micro that clicks into the ttube.
3.push the button that clicks into the Ttube into the inside of the bar and do what you want with it as long as it is out of the way. then take the grip off.
4.drill a hole the same size as the hole alredy there on the other side exactly.
5.screw that into the bottom of the camera,(may need longer screw or washers).
6.dril a hole that is the same angle of the first hole on the opposite side of the grip/bar completely through the bar(two holes)
7.find a very long screw that is the same diameter as the first screw (for me it was 135mm)
8.repeat steps 2, 3, and 4 on another bar/grip except do not take the grip off
9.find some spacers (bearings also work) and put them in between the top bar/grip with the grip on it, And the bottom bar/grip with the holes
10. find that long screw and put the grip with the grip on first then put the bearings/spacers then put the grip connected to the camera through.
11. find a nut the fits your screw and tighten it and your done
sorry if this wasnt detailed enough but i will post pictures of the finished product soon
EDIT:
1.first off find a screw that fits it the threaded hole in the bottom of the camera, about an inch.
2.find a bar/grip from a razor scooter or micro that clicks into the ttube.
3.push the button that clicks into the Ttube into the inside of the bar and do what you want with it as long as it is out of the way. then take the grip off.
4.drill a hole the same size as the hole alredy there on the other side exactly.
5.screw that into the bottom of the camera,(may need longer screw or washers).
6.dril a hole that is the same angle of the first hole on the opposite side of the grip/bar completely through the bar(two holes)
7.find a very long screw that is the same diameter as the first screw (for me it was 135mm)
8.repeat steps 2, 3, and 4 on another bar/grip except do not take the grip off
9.find some spacers (bearings also work) and put them in between the top bar/grip with the grip on it, And the bottom bar/grip with the holes
10. find that long screw and put the grip with the grip on first then put the bearings/spacers then put the grip connected to the camera through.
11. find a nut the fits your screw and tighten it and your done
sorry if this wasnt detailed enough but i will post pictures of the finished product soon
EDIT:
