Need Help Removing Old Bearing Cups with Flat Head and hammer?

[Scooterkid180]

I swear if hit it like 200+ times with a flathead screwdriver and hammer? am i doing it wrong, or not hitting it hard enough?

 

[Ian Marshall]

Not hitting hard enough.

 

[Ben Para]

i was convinced mine were somehow glued in or something. you just need to whack it and go around the whole cup. i messed up the inside of my headtube a bit but you just need to pound it.

 

[RyanNew]

This is what i did, i could not budge it with a flat head, so i got the handle bit that clicks in on stock bars and put that in there and smacked that. It came out in about 10 good hits.

 

[Hep Greg]

This is what i did, i could not budge it with a flat head, so i got the handle bit that clicks in on stock bars and put that in there and smacked that. It came out in about 10 good hits.

do this.

 

[Dean Bost]

get the t-tube out of your old razor bars and use the bottom as something to hit it out and hammer it......like 3 hits and it came right out

 

[dezbert]

get the t-tube out of your old razor bars and use the bottom as something to hit it out and hammer it......like 3 hits and it came right out

Exactly what happens with me every time. Do this^^