One piece bars on razor pro. help!

Status
Not open for further replies.
S

shredbergen

Member
hey, i was searching and i cant seem to find a straight answer on how to EXACTLY apply one piece bars onto a stock razor pro.
any advice???
 
B

BenTen

Member
1. Take a pinch of common sence
2. A cup of searching
3. And half a brain

Stir together thoroughly.

If after that bars arent on scooter
JUMP
 
H

haydenscoots1151

Member
its just like puttin normal bars on
just put the clamp over the end of the bars and put the bars onto the forks
aline the forks and bars so there straight
then start tightening the clamp

hope that helps
 
Y

yzracer94

Member
its easy just put them on like you put stock bars on just slip them on your forks and tighten clamp..dont forget to make them straight
 
A

andrew62396

Member
This isnt Rocket Science .
take ur stock bars off
put the clamp on ur new bars
put ur new bars on the fork
align the bars to ur fork
tighten the clamp
 
P

pron

Member
okay im giving the simple and complete explanation

1. loosen the clamp on your stock bars.
2. pull off or unscrew your bars from your fork.
3. remove the clamp from your stock bars and slide them onto your one piece bars.
4. slide your bars onto your forks and align them with your forks.
5. make sure your bars havnt turned and tighten the clamp all the way at the bottom of the bars.
6. after you ride a little your bars might loosen due to new threads being pressed into your bars.
7. if so just align bars again and re-tighten
 
Status
Not open for further replies.
Top