Pegs with TSI forks?

[Ian Marshall]

I have a TSI thom cat fork, and I just ordered Tilt pegs. On account of me being an idiot, I forgot The the only thing on my TSI fork is 1 bolt with threads on 1 side. Not to mention I dont think The peg will fit on the circular fork leg very well. Can anyone give me some help here on how to make my forks peg-compatible?

 

[nickbrah]

If you look at the clamp on stock razor bars there should be a semi circle thing that the bolt goes through, try drilling that out to fit your axle/axle bolt.

 

[jordan1]

wheel spacers put it in the circular part then put the peg on

 

[nickbrah]

oh yea, thered be a flat bit ay. just use a spacer

 

[Hep Greg]

Peg on the nut side:

get a longer bolt, tighten the bolt so the wheel is tight. then, put the peg onto the bolt, and get a nut and tighten the nut onto the peg so it pushes the peg into the leg of the fork.


peg on the open hole side:

get a longer bolt, and tighten the bolt through the peg. mark off where the bolt sits flush with the nut when tightened, and cut it.

 

[keons5]

peg on the open hole side:

get a longer bolt, and tighten the bolt through the peg. mark off where the bolt sits flush with the nut when tightened, and cut it.

You may end up needing a longer bolt than I included. Send me an email if I need to send you a different bolt.

 

[Thom Cat]

I can send you a long axle uncut, with a nut, or if you dont want to wait. You can find it at Ace Hardware $1, the size would be 8mm x 60mm,

 

[Ian Marshall]

I can send you a long axle uncut, with a nut, or if you dont want to wait. You can find it at Ace Hardware $1, the size would be 8mm x 60mm,

Peg on the nut side:

get a longer bolt, tighten the bolt so the wheel is tight. then, put the peg onto the bolt, and get a nut and tighten the nut onto the peg so it pushes the peg into the leg of the fork.


peg on the open hole side:

get a longer bolt, and tighten the bolt through the peg. mark off where the bolt sits flush with the nut when tightened, and cut it.

You may end up needing a longer bolt than I included. Send me an email if I need to send you a different bolt.

Thom, thanks theres and Ace like 2 minutes for my house.

Hep, thanks, I understand how to do it now.

Keons, I'll definitely contact you if that bolt for Ace doesnt work.

Thanks a lot guys. This what makes SR great, being able to contact the owner of a company instead of them just being a name. Not to mention getting help from people like hep greg.

 

[KieranPeterson]

Digging this thread up from a few months ago. In hep greg's answer for having the peg on the threaded side of the fork, how would you tighten the nut if it was inside the peg? Im not sure if i understand his answer correctly...

 

[Spicy McHaggis]

buy a hardline peg haha