sorry another noobish problem. I ride stock bars and ther shite, they always rattle etc. i decided to cut a 15 inch long piece of metal to use as bars. only problem is...its too tough and i cant drill through it! does anybody know what kind of metal are stock bars made from? wen i know what the metal is i wil make my 5inch wide bars, slap some grips on and bolt it all together! then i shud ut a pic up on here lol can anybody help me out?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
[poll] bars
- Thread starter simson127
- Start date
scootbobby
Member
nah its piss to dril through, jus make sure ur drill is fully charged, when ur drillin apply pressure then realease then apply pressure then release. in a quick cycle type
hope that helps
hope that helps
WayFastRevo
Member
stock bars are aluminum,
what does where are you from do with anything?
what does where are you from do with anything?
tomborsari
Steel Member
before you drill, put a dent/ hole in it with a nail or something sharp and hard