Problems With My QCS Fork!

[JordieRobinson]

My QCS Fork Came Bent In The Mail + It's Too Long So I Spent an Hour Grinding And Sanding Just To Get It To Work With My SCS. I Was Just Wondering If Anyone Else Had These Same Problems With There QCS Fork?

 

[Kyle]

is it bent at the shaft or the tines?

Ask Lloyd though

 

[JordieRobinson]

is it bent at the shaft or the tines?

Ask Lloyd though

Shaft?? Tines??? its bent where the fork holds the axle

 

[Jacob D.]

Shaft?? Tines??? its bent where the fork holds the axle

it's not bent. Lloyd stated that there were imperfections, and that the spacers needed to be grinded down, as well as the axle holes being drilled. I'm getting scs soon so im happy i dont have to have a starnut <3

 

[Kyle]

I thought you ment the shaft of the fork was bent sideways. And tines I ment to say tongs. Ill check mine though.

Edit: Mine are fine.

 

[rmaccbik3s]

instead of sanding and grinding you should have slapped a spacer under it.

 

[JordieRobinson]

instead of sanding and grinding you should have slapped a spacer under it.

na man, i hate the look of spacers

 

[Jacob D.]

instead of sanding and grinding you should have slapped a spacer under it.

are you retarded? the axle spacers are too big, why the fuck would you put another one in there?

 

[TUC]

are you retarded? the axle spacers are too big, why the fuck would you put another one in there?

he means put a spacer on the steerertube instead of cutting it down...

 

[keons5]

are you retarded? the axle spacers are too big, why the fuck would you put another one in there?

I think he was talking about an 1-1/8" threadless bmx headset spacer to raise the SCS, not the axle spacers.

 

[TristanVesely]

it's not bent. Lloyd stated that there were imperfections, and that the spacers needed to be grinded down, as well as the axle holes being drilled. I'm getting scs soon so im happy i dont have to have a starnut <3

SCS still has a starnut dumbass...

 

[Stevenson]

SCS still has a starnut dumbass...

QCS fork as an integrated thread for SCS dumbass.

 

[Hep Greg]

why would you sand/grind instead of cutting your forktube lol.

it doesnt have to be perfectly straight to work with an SCS...

 

[JordieRobinson]

why would you sand/grind instead of cutting your forktube lol.

it doesnt have to be perfectly straight to work with an SCS...

because it took forever to cut it with a hack saw because the fork tube is soo thick.