scorcher fork lock nut axel

[JasonEwing]

lock nut as a axel and i was wondering how do you tighten and loosen it because you cant fit a socket wrench in it. When i tried all that happened was the nut would start to strip becasue there isnt enough room to fit pliers or a socket wrench

 

[Noah.]

just use a wrench

 

[JasonEwing]

i tried there isnt enough room to grab the bolt

 

[ConnorD]

am I the only one who didnt understand your first post at all? Rephrase that bro

 

[JasonEwing]

when i put the axel throught the fork and tighten the bolt the isnt enought room to tighten it all the way or loosen it becasue of the way the nut sits

 

[Kroto]

Get a new axle then

 

[Rob.]

Get some washers and a slightly longer bolt?

 

[JasonEwing]

its not the bolt its plenty long and they dont make washers that small with that big of a hole

 

[skoot.or.die]

use a crescent wrench to grab the end of the bolt then just tighten it. i had the same problem when i tried to put pegs on my phoenix phorx with a short bolt

 

[Snyder]

nigger rig a few pennies a penny for a washer.

 

[Rob.]

get a longer bolt and use wheel spacers?

 

[JasonEwing]

my axel is the bak axel of a phoenix deck and a penny wont fit only a dime would the oly thing i could think of trying is to use needle nose pliers

 

[Derek Seay]

put a flathead screqwdriver between a flatside of the nut and the fork hole and tichten the allen side

 

[Hunter Treviranus]

i have a scorcher with a bolt and locknut and it work fine just use a wrench

 

[JasonEwing]

yah hunter that didnt work with mine idk why but it just used half of a bearing spacer it i can use a socket wrench