Slits

[TheAt0m]

I just started scooting and got a razor ultra pro, but i got the wrong size and need to cut them. Any tips on making slits? The main thing is i need to know if i have to drill the circke at the end of the slits.

 

[dpnelson31]

Just use whatever you cut the bars with to cut the slit.
You don't have to drill the hole but you need to make sure the slit is wide enough so it doesn't clamp shut and not grab your bars fully. Just pry it open with a screwdriver some before putting it back on.

And people will lecture you for not searching or putting this in the wrong section. Just look around and watch out for assholes everywhere on this site.

 

[Grant Schofield]

noo you do need yo put the cicle at the top other wise your bar will crack up the bars

 

[Mickey G.]

^^ Don't listen to him, He doesn't know what he is talking about.

 

[Rob.]

no really thats what the drill stop is for.
i'd drill a hole

 

[Hep Greg]

draw out the slits before you cut them, drill a small hole at the top of it, then use a hacksaw to SLOWLY cut them. if you rush this process, you'll hve crooked slits, and possibly unusable bars.