Snapped Bolts In Scs?

[Ryskie_UK]

I snapped 2 bolts in my scs and the threaded part is stuck inside, and the head of the bolt snapped of.
Do you know a way to get it out without drilling it?
Thanks

 

[AshleyPowell]

There is a way if getting it out with a drill BUT without removing the threads on the clamp. You take the drill and a drill bit that it about 2/3 the size of the bolt and drill a pilot hole about 2mm deep and then take the drill bit the next size up. And apply quite a lot of pressure and the threaded part of the bolt should twist out.

 

[Robert]

^yes

 

[morgan_bvrns]

Or you can get these hardened steel things. You drill a hole into the bolt, then put one of these things (it looks like tapered drill bit with a long, steep thread. Someone help me out here) in the drill, and you should be able to just twist it right out if its not too tight.

 

[ConnorD]

Get an extractor kit from a hardware store. They look like screws with reverse threads, and you put them on your drill.
Without drilling them out, if there's a little bit of the thread sticking out, unscrew it with needle nose pliers.

 

[mukiteoscoots]

take another bolt and screw it in until the other one comes out.

 

[CollinDonnelly95]

Use a grabit (;