SR Metalcore Review

[Tylerr.]

lol, just get them lined up and use a hammer unless you care to much about ur bearings... but 1 thing i do is just but bearing at bottom of wheel then just stand on the wheel and it just goes in nice and gentle =]

i jumped off a wall with my wheel upside down with the berning half way in and it didnt budge

 

[maxlikesscooters]

wow

 

[codyferner]

i just hammered on a front wheels axle through the bearings and they went in after 30 minutes of pounding

 

[maxlikesscooters]

that's nice
i'm excited now

 

[LukeMaff]

IF YOU have a skateboard truck u can just get it out buy sticking the truck bit where wheels hold onto it and pop it out like ur openeing a can ... if that makes sense?

 

[dezbert]

that's very smart^^^

 

[KelbySinghausIsGone]

Yeah, I'm not aloud to ride mine till Christmas =[ I'm stoked though.

haha, me either.

 

[koenscoot]

IF YOU have a skateboard truck u can just get it out buy sticking the truck bit where wheels hold onto it and pop it out like ur openeing a can ... if that makes sense?

Yeah thats what i done with my eagles.
And also, to get bearings in, id recomend
a bearing press.
Get a 5/16 thick bolt (or a skateboard truck)
line it up (bolt, washer, bearing, wheel and spacer, then the other bearing, another washer, nut.
get two wrenches to tighten it.
or put the end of the bolt in a vice and a wrench to thighten the nut.

 

[max18]

yeah using a hammer on 57 dollar bearings your a f---ing idiot

 

[idk47]

Err..
Did anybody think about how they'd get the bearings OUT?

A miracle.

 

[conordavidson]

yeah using a hammer on 57 dollar bearings your a f---ing idiot

Why would you take the bearing out if it's still okay? The only time I'd take bearings out is if it was broken, and then I wouldn't care if I destroyed it in the process of hammering it out.

 

[DonaldM]

To clean them

 

[conordavidson]

Oh...true.

 

[devinthedew]

USE ONE MOF THOSE RUBBER HAMMAERS IT WORKS THE BEST