Threshold axle problem need help now!

[Austin Forkner]

Ok well I just got a threshold and the the axle came with 4 spacers and I'm running 110 blunt wheels and the the wheel is loose without the spacers but it's really tight and will barely spin with 2 spacers and all 4 spacers won't even fit. So what do I do?

 

[morgan_bvrns]

Do you have a bearing spacer in your wheel?

 

[Austin Forkner]

Yes I have bearing spacers but it's the axle spacers that I don't get.

 

[Robert]

Yes I have bearing spacers but it's the axle spacers that I don't get.

take a hammer and hit the washers to flatten them out, until the fit.

 

[Austin Forkner]

Nevermind guys just got it on but it was a pain in the ass. Also are the wheels supposed to be really close cause my rear wheel is like really close it's almost dragging the brake my wheel is 110 but I don't know ifthey sent me a 100mm brake or if they r just supposed to be that close.

 

[Robert]

Nevermind guys just got it on but it was a pain in the ass. Also are the wheels supposed to be really close cause my rear wheel is like really close it's almost dragging the brake my wheel is 110 but I don't know ifthey sent me a 100mm brake or if they r just supposed to be that close.

is it just touching the brake, or will the wheel not fit in because of it?

 

[Austin Forkner]

Ya it's just touching the brake it fits bit its just like soooooo close to touching the brake

 

[Anton]

Put a spacer under the brake in the 2nd hole. The one furthest from the brake. It will tilt the brake up and should fit.

 

[dpnelson31]

It is supposed to be like that.
Enjoy the deck, man. Mine is shipping today!