Tilt SCS and Fuzion Bars Compatability?

[timmyyyrox2]

So I just got my new tilt scs today in the mail, and I tried putting it on but the bars don't fit. With the shim, its not even close to fitting, and without the shim it moves and there's a little extra room. I tried putting something in there myself, but now the bars twist. Any suggestions?

 

[Stackies]

Do the bars have a slit?

 

[timmyyyrox2]

Not anymore, I cut them off.

 

[Robert]

make your own shim out of a pop can

 

[alexallupinthis]

dont use fuzion bars, they suck

 

[Robert]

dont use fuzion bars, they suck

that doesn't help him

 

[Connorh333]

Steps to do this:
1.Acquire wood and gasoline.
2.Dig a hole in your backyard.
3.Put the wood/gasoline in hole.
4.Light that shit up.
5.Place bars in the flames.
6.Buy new bars
Problem solved!

 

[connor Donnelly]

this




http://www.youtube.com/watch?v=f-LaJVk0lfM

 

[timmyyyrox2]

I just made myself a shim from a soda can, thanks Robert. But I'll definitely be getting new bars soon

 

[Robert Reichley]

What connor said.
But you can make a shim out of a metro card, or cut it from a soda can, or find some other reaaly thin piece of sheet metal

 

[connor Donnelly]

What connor said.
But you can make a shim out of a metro card, or cut it from a soda can, or find some other reaaly thin piece of sheet metal

ya. i had to do this with my ditrict bars.

 

[Dewey]

yea the same thing happened with my freinds half nuck, i dont get why they have to make their bar a different diameter than every other bar

 

[Chris36]

rap it with tape till it gets to the right size then put it in