What Compression System goes with TSI Thom Cat?

[ScoOter_ChilLa]

but i want to reinforce my my fork with a 4mm thick reinforcement.. can i install the starnut UNDER the reinforcement?

 

[Steezeman]

You're not going to have to reinforce that fork, it's strong enough. But if you really want to I'd say put the star nut in then reinforce it. Again, you really don't need to reinforce it.

 

[Kc Corning]

but i want to reinforce my my fork with a 4mm thick reinforcement.. can i install the starnut UNDER the reinforcement?

Did this kid just say he wants to reinforce the steer tube on a Thom Cat?

man...

 

[spencer2251]

Are they even good forks... look weak

 

[Thom Cat]

 

[conordavidson]

You don't need a shim with the baby knuckles. And, you don't need a shim with the normal knuckles had you used oversized bars in the SCS diagram, like you did with the HIC diagram.

 

[keons5]

Sorry to change the subject, but oh my... Learn how to paint man!

I wouldn't try FrenchID ICS. I'd use ICS from Inward with a drilled out starnut. Just run over to your local bike shop, and they'll be able to get you the correct starnut. If you use ICS, don't forget the starnut for your bars as well.

 

[Thom Cat]

You don't need a shim with the baby knuckles. And, you don't need a shim with the normal knuckles had you used oversized bars in the SCS diagram, like you did with the HIC diagram.

as far as I know the red shim in SCS is for 1 1/4 inch bars and if you take it out you can run 1 3/8 bars, Andrew did this so it would fit both, yes your right.

I drew this so poeple could see the HIC (because its hidden)
These are the two compression systems that work with this fork
(I DO NOT RECOMEND ICS)
and ya its not a good paint job (needs another coat)

 

[ScoOter_ChilLa]

but i want to reinforce

so if i want to make it like TomK said, it works also with a standart razor clamp, right?

and how long takes the shipping of the thom cat?