What the fuck.

Status
Not open for further replies.

Zaηe

Keepin' Peace
Staff member
How come i have to hammer my strikers like fuck (dw i found a safe way) to get them into my Hardline shorties?
 

TomK

Super Moderator
Staff member
its cause the bars use the wrong size tubing. They use .065" wall which does work right on threadless. They should have used .058" wall.
 

edy boi

Member
its so there stronger but it is kinaoff a fail scs really is the way to go.... oh or hic but ics is kindaaaa ...............
 

Zaηe

Keepin' Peace
Staff member
i was going yo use the hardline ics with welded starnut.
i can get the forks in the bars, but now i cant get them out FML.
 

Riley Hughes

Steel Member
its so there stronger but it is kinaoff a fail scs really is the way to go.... oh or hic but ics is kindaaaa ...............
with hic you still have to put the bars over something. if the bars aren't the right ID then scs is the way to go.

zane, brace the bars and slam downwards on the deck. like put the crossbars on a table and kick, or something. that's how i did it, haha. be sure not to bend the bars
 

Zaηe

Keepin' Peace
Staff member
i lengthened the slits.
dont worry guys, i broke the welded starnut and now my dads going down to his mates to see if he can get the fucking things off with an oxy.
wich is useless anyway because the starnut is fucking broken.
thanks a fucking lot. i just wasted $100 on bars that have compression but cant work on compression.
 

Zaηe

Keepin' Peace
Staff member
fuck the starnut, it still works it just slides up and down lmao.
save up for scs.
 
Status
Not open for further replies.
Top