Whats going on?

[D-Worden]

I got new tilt forks yesterday and i put them on my scooter. i put my shim on and tightend the top cap down. I put my bars on and tightend my clamp. My set up is super tight but today i rode and i did some smiths and realized my bars were crooked i fixed it and kept riding. after a few other tricks i saw my bars were turned again. whats causing this?

 

[Robert]

What type of hic shim do you have?

or are you running scs?

 

[D-Worden]

Homemade shim.

 

[madzach22]

your compression could be loose wich would cause the shim to spin and you bars are clamped to a loose shim would cause your bars to move

 

[.Gerrit]

 

[yoyoflavored]

Does your shim have a slit?

 

[yoyoflavored]

Does your shim have a slit?

 

[D-Worden]

yeah the shim has a slit.

 

[Robert]

is it longer than the fork?

 

[D-Worden]

yeah its a little over a half inch longer when set on my topcap over the forks.

 

[dpnelson31]

Slit in your bars might not be wide enough. Tighten them and see when the slit closes.